514 Chapter 8 Removal & Installation
Removal & Installation
19. Remove the Curing Temperature Sensor Fan through
the hole in the Curing cover.
20.Remove the Curing Temperature Sensor through the
hole in the Curing cover.
Installation
1. When installing the Curing Temperature Sensor fan, it
is important that the label of the fan is not visible.
2. In this example the fan is correctly installed.
NOTE: After installing the NEW Curing IR
Temp sensor & Fan perform the following:
• Reset the life counter “4.8.2 Reset Curing
Sensor”
⇒
page 201.
To Next Page
Loading...