Curing Heaters 515
Removal & Installation
Curing Heaters
Removal
1. Remove the Left Cover
⇒
See page 325
.
2. Remove the Left Curing Cover
⇒
See page 328.
3. Remove the Right Curing Cover
⇒
See page 330.
4. Remove the Curing Fans Cover
⇒
See page 503.
5. Loosen two screws on the connector of the Curing IR
Temperature Sensor cable, by hand or with a flat
screwdriver.
6. Disconnect the Curing Temperature Sensor Cable.
7. Disconnect the cable of the Left Windows Lock Sensor.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...