78 Chapter 3 System Error Codes
System Error Codes
Continuable and Non-Continuable Error Codes
Some of the Error Codes are continuable, which means you can press Enter on the front-panel and
continue working with the Printer. Non-Continuable Error Codes do not allow you to continue working
with the Printer, in this case power the Printer OFF and ON again and see if the System Error disappears.
If the Error Code reappears, then the Printer requires an on-site visit in order to resolve the problem.
Important note: If the solution calls for a replacement part, replace one component at a time and check
if the error has been cleared before replacing another component. Using this procedure you will be able
to determine exactly which component has failed.
SE Code: 01.0:03 - Error impact I2C channel
Problem Description:
There is an error with a board in the Electronics Module.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• If the System Error continues, replace the Sausalito PCI PCA ⇒ Page 444.
SE Code: 01.0:10 - Problem with the Sausalito PCA
Problem Description:
The Sausalito PCI PCA has failed
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Replace the Sausalito PCI PCA ⇒ Page 444.
• If the System Error continues, replace the Main PCA ⇒ Page 450.
SE Code: 01.1.10 - Problem with the Printmech PCA
Problem Description:
The PrintMech PCA has failed to respond.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the cables between the PrintMech PCA and the Sausalito PCI PCA are not damaged and
are correctly connected.
• Replace the PrintMech PCA ⇒ Page 464.
• If the System Error continues, replace the Sausalito PCI PCA ⇒ Page 444.
SE Code: 01.02:10 - ISS PCA Problem
Problem Description:
The ISS PCA has failed to respond.
To Next Page
Loading...