Copy a document
Follow the steps below to make a copy (scan to print).
1. Insert and feed your document into the scanner, with the side to be scanned
facing upwards.
2. Make sure the printer is turned on and the intended media is loaded.
NOTE: To copy, you need a media profile for the loaded media. The system
comes with a set of media profiles for the most commonly-used media. If you
need to create a new media profile, see
Create a media profile
on page 19.
3. Press the Copy button to access the copy (scan to print) settings and buttons.
The Copy dialog is shown below.
4. Press the Original Type button and select the type that matches your
document and required output. See
Specify the original type and make image
adjustments on page 11.
5. Press the Quality button and select the desired quality of your output.
6. Press the Scan Area button to set the size of the image capture area. If you
wish to capture the whole image, select Auto and the system will measure
and set the size for you.
7. Press the Resize button to determine the size of the printed copy. Set to No
if you want a 1:1 copy.
8. Press the Copies button to select how many copies you want printed with the
job.
9. Toggle the Preview before Copy button to On if you want to control settings
before committing the job to the printer. See
Preview copies and scans
on page 15.
10.
When you have made your settings, press the Start Scan/Copy button
to
start copying.
8 Chapter 2 Basic operations ENWW
Basic operations
Learning Products Barcelona - Hewlett-Packard Company
To Next Page
Loading...