HP Designjet T1120 SD - Lines in the scanned image appear too thin or discontinuous; Cannot connect or scan to a destination folder on the LAN

Calibrate the touch screen pointer
1. Press Options > Advanced Options > Calibrate Screen.
NOTE: Access to the Advanced Options may require the system’s
administrator password.
2. Follow the instructions on the screen. Calibration is done by pressing target-
points that appear in different positions on the screen. Press the target-points
until they no longer appear.
3. Press the OK button in the final dialog to confirm and conclude screen
calibration.
Replace the scanner glass plate
Over time, the condition of the glass plate can deteriorate. Small scratches on the
glass surface can reduce image quality. Call HP Support to order a new glass plate.
Step-by-step instructions on replacing the glass plate are supplied with the new
glass plate.
ENWW
Calibrate the touch screen pointer
29
Maintenance
Learning Products Barcelona - Hewlett-Packard Company