Control access to the printer
Front-panel security settings
From the front panel, you can press , then , then Security, to control some of the features of the
printer.
●
USB drive: Enable or disable the use of a USB flash drive.
●
Firmware update from USB: Enable or disable firmware updates from a USB flash drive.
●
Internet connection: Enable or disable the Internet connection.
NOTE: If you disable it, you also disable automatic firmware updates and remote printing.
●
Enable HP Connected: Enable or disable the use of HP DesignJet ePrint with a computer connected
directly to the printer.
●
User sessions: Enable or disable automatic log-out after 1, 3, or 5 minutes.
●
Printer access control: Enable, disable, or change the administrator password.
If an administrator password has been set, it must be given in order to perform the following operations:
●
Change the security settings (including the administrator password itself)
●
Change the configuration of the Internet connection
●
Change the Automatic Firmware Update configuration
●
Enable or disable automatic downloading and/or installation of automatic firmware updates
●
Restore an earlier firmware version
●
Reset factory defaults
NOTE: The administrator password can contain only characters that appear on the front panel's on-screen
keyboard. If you set a new password with the Embedded Web Server, it will reject characters that do not
appear in that limited character set.
32 Chapter 3 Setting up the printer ENWW
To Next Page
Loading...