5. Close the scanner cover and gently push it down to lock it into place.
6. Clean the area immediately in front of the scanner, where the scanned sheet rests before scanning.
7. Reconnect the printer's power cable, turn on the power switch at the rear, and turn on the printer using
the Power key.
Replace the scanner’s glass plate
Over time, the condition of the glass plate can deteriorate. Small scratches on the surface of the glass can
reduce image quality. Contact HP Support (see Contact Support on page 237) to order a new glass plate.
1. Turn off the printer using the Power key at the front, then also turn off the power switch at the rear and
disconnect the power cable.
ENWW Replace the scanner’s glass plate 155
To Next Page
Loading...