●
The borders of colored blocks are wrongly colored.
To correct this kind of problem:
1. Align the printhead. See Align the printhead on page 224.
2. Reseat the printhead by removing and then reinserting it. See Remove the printhead on page 139 and
Insert the printhead on page 142.
Lines are discontinuous
If your lines are broken in the following way:
1. Check that you are using appropriate print-quality settings. See Printing on page 66.
2. When printing on uncoated paper in Fast mode, try loading the paper as Bright Bond.
3. Align the printhead. See Align the printhead on page 224.
4. Reseat the printhead by removing and then reinserting it. See Remove the printhead on page 139 and
Insert the printhead on page 142.
Lines are blurred
Humidity can cause ink to soak into the paper, making the lines blurred and fuzzy. Try the following:
1. Check that your environmental conditions (temperature, humidity) are suitable for high-quality printing.
See Environmental specifications on page 244.
2. Check that the paper type selected in the front panel is the same as the paper type you are using. See
View information about the paper on page 60.
ENWW Lines are discontinuous 185
To Next Page
Loading...