●
Protocol may be FTP or CIFS (Windows).
●
Folder type may be public or private. The folder type is displayed in both the Embedded Web
Server and the front panel with an icon. When you select a private folder, you must enter a
password in the front panel.
●
Alias name is displayed in the front panel when you are choosing the scan destination. It may be
different from the network or FTP folder name.
●
Set this network destination as a default. If you have installed HP Designjet SmartStream, the
option to set it as a destination appears. See HP SmartStream on page 166.
●
Server name should contain the network name of the remote computer.
●
Folder name should contain the share name of the folder.
●
User name should contain the name of the 'scanner user'.
●
User password should contain the password of the 'scanner user'.
●
Domain name should contain the name of the domain in which the user name exists. If the
'scanner user' does not belong to any domain, leave this field empty.
The server and folder names are used to connect to the shared folder by building a network folder path
as follows: \\server name\folder name
For a network folder, enter the name or IP address of the remote computer, the name of the shared
folder, and the user name and password of the 'scanner user' that you have already created on the
remote computer. Leave the user domain field empty unless the user is a member of a Windows
domain. If the user is only a local user of the remote computer, leave the field empty. You can use the
name (instead of the IP address) in the server name field only if the shared folder is on a Windows
computer in the same local network. This must be a simple name (up to 16 characters long) without a
domain suffix (without any dots in the name). Fully qualified DNS domain names are also supported.
For an FTP folder, enter the server name, folder name, user name, and password. Leave the user
domain empty.
22 Chapter 3 Setting up the printer ENWW
To Next Page
Loading...