●
Enable HP Connected Center connectivity.
●
User sessions: Enable or disable automatic log-out after 1, 3, or 5 minutes.
●
Printer access control: Enable, disable, or change the administrator password.
If an administrator password has been set, it must be given in order to perform the following operations:
●
Change the security settings (including the administrator password itself)
●
Change the configuration of the Internet connection
●
Change the Automatic Firmware Update configuration
●
Enable or disable automatic downloading and/or installation of automatic firmware updates
●
Restore an earlier firmware version
●
Reset factory defaults
NOTE: The administrator password can contain only characters that appear on the front panel's on-screen
keyboard. If you set a new password with the Embedded Web Server, it will reject characters that do not
appear in that limited character set.
Embedded Web Server security settings
From the Embedded Web Server, you can select the Security tab to control access to the printer in various
ways:
●
Specify separate administrator and guest passwords to control access to the Embedded Web Server
●
Securely erase some or all files on the hard disk
●
Enable or disable various groups of front panel operations
●
Use the same security settings that are available in the front panel (see above)
NOTE: An administrator password may be required.
NOTE: For more information, see the Embedded Web Server's online help.
To control access to the Printer front panel from the Embedded Web Server, go the Setup tab, and select
Security.
The following options will be available:
●
Unlock: unrestricted access to the front panel.
●
Minimum Lock: unrestricted access to the front panel.
●
Moderate Lock: in addition to minimum lock, denies access to printer, scan, copy and print from usb.
30 Chapter 3 Setting up the printer ENWW
To Next Page
Loading...