3. The spindle has a stop at each end. The blue stop can move along the spindle and has a latch to lock it in
place. Open the latch and remove the blue stop from the end of the spindle.
NOTE: For loading 3 inch core rolls, use adaptors in the spindle; insert an adaptor into each hub,
making sure they protrude, and that the blue tabs can be seen on the external side of the hub, and are
firmly in place.
4. If there is already a roll or core on the spindle, remove it.
5. If the roll is heavy, rest it horizontally on a table and insert the spindle into it.
TIP: You may need two people to handle a large roll.
6. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not, remove
the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the spindle showing
the correct orientation.
NOTE: From the front of the printer, the blue stop should be inserted into the right-side holder.
Ensure both ends of the roll are as close to the spindle stops as possible.
ENWW Load a roll onto the spindle 51
To Next Page
Loading...