NOTE: The use of USB flash drives with your printer may be disabled in the Embedded Web
Server (Setup > Security > Disable USB drives).
●
Into a network folder (a folder on a computer that is accessible through the network)
NOTE: The network folder option will not work unless the network folder has been correctly set
up and identified in the Embedded Web Server or HP Utility: see Configure a scan-to-network or
scan-to-FTP folder on page 21.
TIP: To check the Scan default destination, go to the front panel and press , then .
●
Into an email message. In this case, you must give the email address(es) to which the scanned job
will be sent. The printer remembers these addresses by default, but you can tell it not to do so:
press , then Security > Auto store email recipients > Off.
NOTE: Scanning to email will not work unless the email server has been correctly configured.
See Configure the email server on page 26.
●
Into HP SmartStream, if you have bought the software and your printer is connected to it. See HP
SmartStream on page 166.
4. The list of scan quicksets is displayed. You can choose and/or edit one of the quicksets for the current
job. If you want to change a quickset permanently, or create a new one, press , then Print, Scan &
Copy quicksets, Scan quicksets. For more information on quicksets, see Quicksets on page 47.
The following settings are available. They are divided into three categories: settings for the original
document, settings for how to scan the job, and settings for how to save the job.
●
Quickset name allows you to name the quickset you are working with.
Original
●
Content type allows you to optimize the scan for a line drawing, a photographic image, or a mixed
image.
●
Background removal allows you to remove unwanted background color. You can specify the
strength of this setting, from 0 to 10.
●
Original paper type allows you to specify the paper type on which the original document has been
printed. To optimize scan quality, ensure that this setting is correct.
●
Blueprints invert allows you to generate a scanned image with a light background. It is useful
when the original you intend to scan is a blueprint with a dark background. This option is available
only if the Original type is set to Blueprints.
Scan settings
●
Resolution allows you to specify the scan resolution: Standard (200 dpi), High (300 dpi), or Max
(600 dpi).
●
Color options allows you to choose color, grayscale or black and white scanning.
●
De-skew: The scanner has a built-in automatic de-skew algorithm, which measures the skew in
the original, and rotates the scanned image so that the result is perfectly straight.
●
Full width margins are not detected doing a complete scan.
84 Chapter 9 Scanning ENWW
To Next Page
Loading...