Message or code Recommendation
61:08 Resend the job.
61:08.1 The job cannot be printed because it is password-protected.
61:08.2 The job cannot be printed because it contains errors. Resend the job from the
Embedded Web Server.
61:09 Resend the job.
63:10 • Turn o the printer using the Power button at the front.
• Turn o the power switch at the rear.
• Disconnect the power cord.
• Reconnect the power cord and turn on the printer.
• Check that the network cable is correctly connected.
• Ensure that the printer’s rmware is up to date.
63:20 A potential problem has been detected in the network interface.
• Turn o the printer using the Power button at the front.
• Turn o the power switch at the rear.
• Disconnect the power cord.
• Reconnect the power cord and turn on the printer.
• Send the same job to the printer again.
• Ensure that the printer’s rmware is up to date.
71.03, 71.08 Out of memory. To avoid this, in the HP-GL/2 driver select the Advanced tab
and then Send job as a bitmap.
74.01 An error occurred when loading the rmware update le.
• Turn o the printer using the Power button at the front.
• Turn o the power switch at the rear.
• Disconnect the power cord.
• Reconnect the power cord and turn on the printer.
• Reload the rmware update le into the printer.
74.1:04 Try the rmware update again. Do not try to use your computer while the
update is in progress.
74.8:04 The rmware update has failed. Your rmware le may be incorrect; try to
download it again.
75.11:10 Preventive maintenance 1 is recommended.
75.21:10 Preventive maintenance 2 is recommended.
76:03 The printer’s hard disk is full. You may want to use Disk Wipe to free some
space.
78:08 Borderless printing not possible; setting ignored. Ensure that the loaded paper
supports borderless printing.
79:03, 79:04 Update your printer’s rmware.
81:01 Lift the scanner and make sure that there are no obstacles restricting the
movement of the drive roller. If the paper has jammed, clear the obstruction by
following the instructions in the front panel.
86:01 Lift the scanner and make sure that there are no obstacles restricting the
movement of the printhead’s carriage. If the paper has jammed, clear the
obstruction by following the instructions in the front panel.
94, 94.1 Restart color calibration.
To Next Page
Loading...