When the printer is powered back on, it takes about three minutes to initialize and check and prepare the
printhead.
NOTE: When the printer has not been used for a certain period of time (the default time is determined by
Energy Star), it saves power by going into sleep mode. However, any interaction with the printer's front-panel
display, or sending a new job to print, returns it to active mode, and it can resume printing immediately. To
change the sleep mode time, see Change the sleep mode setting on page 29.
Reports
The reports give various kinds of information about your printer. They can be requested from the front panel.
Before requesting any info prints, check that the printer and the paper are ready for printing. The loaded
paper should be at least A4 portrait—210 mm (8.27 in) wide—otherwise the print may be clipped.
To print any report, swipe down the dashboard, touch , then scroll down to Reports and touch it, then
select the report you want. The following reports are available.
●
Demo prints: show some of the capabilities of the printer
◦
Drawing demo
◦
Rendering demo
◦
GIS map demo
●
User info prints
◦
Printer status report
◦
Print quality report
◦
Network Conguration Page
14 Chapter 1 Introduction ENWW
To Next Page
Loading...
