HP Designjet Z5200 - PostScript Printer Using

Before requesting any internal print, make sure that paper is loaded (roll or sheet), and that the front
panel displays the Ready message. The loaded paper should be at least A3 landscape—420 mm
(16.53 in) wide—otherwise the print may be clipped.
To print any internal print, select the Internal Prints menu icon
, then select the internal print you
want. The following internal prints are available.
●
Demo prints: show some of the capabilities of the printer
◦
Print black and white photo
◦
Print color photo
◦
Print color design demo
◦
Print GIS map
NOTE: Demo prints are printed the same size as the loaded paper.
●
Menu map: shows details of all the front-panel display menus
●
Configuration: shows all the current front-panel display settings
●
Usage report: shows estimates of the total number of prints, number of prints by paper type,
number of prints by print-quality option and total amount of ink used per color (the accuracy of
these estimates is not guaranteed)
●
Service information: provides information needed by service engineers
●
PostScript font list: shows PostScript fonts available
8 Chapter 1 Introduction ENWW
Introduction

HP Designjet Z5200 - PostScript Printer Specifications

General

Print Technology	Thermal Inkjet
Number of Inks	8
Memory	32 GB (virtual)
Hard Disk	160 GB
Line Accuracy	+/- 0.1%
Maximum Print Resolution	2400 x 1200 dpi
Ink Colors	Cyan, Magenta, Yellow, Light Cyan, Light Magenta, Light Gray
Media Sizes Supported	Up to 44 inches wide
Connectivity	Gigabit Ethernet (1000Base-T), Hi-Speed USB 2.0
Minimum Line Width	0.02 mm
Maximum Optical Density (Black)	2.5
Media Types	Bond and coated paper, photographic paper, self-adhesive and banner
Media Sizes Standard (Sheets)	A4, A3, A2, A1, A0
Media Sizes Standard (Rolls)	24 to 44-in rolls
Media Thickness	Up to 0.8 mm
Connectivity, Standard	Gigabit Ethernet (1000Base-T); Hi-Speed USB 2.0 certified; EIO Jetdirect accessory slot
Print Languages	Adobe PostScript 3, Adobe PDF 1.7, TIFF, JPEG, HP-GL/2, HP-RTL, CALS G4
Ink Types	Pigment-based
Operating Temperature Range	5 to 40°C
Dimensions (W x D x H)	1770 x 721 x 1050 mm