HP Designjet Z5200 - PostScript Printer Using

Turn the printer on and off
TIP: The printer can be left powered on without wasting energy. Leaving it on improves response
time and overall system reliability. When the printer has not been used for a certain period of time
(the default time is determined by Energy Star), it saves power by going into sleep mode. However,
any interaction with the printer's front-panel display returns it to active mode, and it can resume
printing immediately. To change the sleep mode time, see
Change the sleep mode setting
on page 22.
NOTE: In sleep mode, the printer performs maintenance service to the printheads from time to time.
This avoids long preparation times after long idle periods. Therefore, it is strongly recommended to
leave the printer powered on or in sleep mode to avoid wasting ink and time.
The printer has three levels of power consumption.
●
Plugged in: the power cord is plugged into the back of the printer
●
Switched on: the switch at the back of the printer is in the on position
●
Powered on: the Power key on the front panel shows a green light
If you wish to turn the printer on or off or reset the printer, the normal and recommended method is to
use the Power key on the front panel.
However, if you plan to store the printer indefinitely or the Power key does not seem to work, you are
recommended to power it off using the Power key, and then also switch off the power switch at the
rear.
To turn it back on, use the power switch at the rear.
When the printer is powered back on, it takes about three minutes to initialize and check and prepare
the printheads. Preparing the printheads takes about one minute and 15 seconds. However, if the
printer has been off for six weeks or more, preparing the printheads could take up to 55 minutes.
ENWW Turn the printer on and off 19
Personal settings

HP Designjet Z5200 - PostScript Printer Specifications

General

Print Technology	Thermal Inkjet
Number of Inks	8
Memory	32 GB (virtual)
Hard Disk	160 GB
Line Accuracy	+/- 0.1%
Maximum Print Resolution	2400 x 1200 dpi
Ink Colors	Cyan, Magenta, Yellow, Light Cyan, Light Magenta, Light Gray
Media Sizes Supported	Up to 44 inches wide
Connectivity	Gigabit Ethernet (1000Base-T), Hi-Speed USB 2.0
Minimum Line Width	0.02 mm
Maximum Optical Density (Black)	2.5
Media Types	Bond and coated paper, photographic paper, self-adhesive and banner
Media Sizes Standard (Sheets)	A4, A3, A2, A1, A0
Media Sizes Standard (Rolls)	24 to 44-in rolls
Media Thickness	Up to 0.8 mm
Connectivity, Standard	Gigabit Ethernet (1000Base-T); Hi-Speed USB 2.0 certified; EIO Jetdirect accessory slot
Print Languages	Adobe PostScript 3, Adobe PDF 1.7, TIFF, JPEG, HP-GL/2, HP-RTL, CALS G4
Ink Types	Pigment-based
Operating Temperature Range	5 to 40°C
Dimensions (W x D x H)	1770 x 721 x 1050 mm