Web Services issues
For any issues with HP ePrint, please refer to the HP ePrint Center: http://www.hp.com/go/eprintcenter.
Automatic file system check
When you turn on the printer, you will occasionally see a front panel display similar to the one shown below.
A file system check is taking place; it can take up to 40 minutes. Please wait until it finishes.
CAUTION: If you turn the printer off before the file system check has finished, the file system could be
seriously damaged, making the printer's hard disk unusable. In any case, the file system check will restart
from the beginning whenever you turn the printer on again.
A file system check is scheduled every 90 days, in order to maintain the hard disk's file system integrity.
NOTE: When the printer is powered back on, it takes about three minutes to initialize and check and
prepare the printheads. However, it can take up to 40 under some conditions, for example, when the printer
has not been used for a long period of time and requires more time to prepare the printheads.
Alerts
Your printer can communicate two types of alerts:
●
Errors: Mainly alerting you to the fact that the printer is unable to work normally. However, in the
printer driver, errors can also alert you to conditions that could ruin the print, such as clipping, even if
the printer is able to print.
●
Warnings: Alert you when the printer needs attention either for an adjustment, such as a calibration or
for a possible unprintable situation, such as a preventive maintenance or low ink.
There are four different alerts communicators within your printer's system.
●
Front-panel display: The front panel shows only the most relevant alert at a time. In the case of a
warning, it disappears after a timeout. There are permanent alerts, such as "ink cartridge low on ink",
that reappear when the printer becomes idle and there is not another more severe alert.
TIP: From the front panel display you can configure paper mismatch alerts, see Paper suitability
options on page 23.
●
Embedded Web Server: The upper-right corner of the Embedded Web Server window shows the printer
status. If there is an alert in the printer, the status shows the alert text.
ENWW Web Services issues 155
To Next Page
Loading...
