170 Chapter 5 Service Calibrations
Service Calibrations
11. The Printer will start to print the OMAS Calibration Pattern. This could take several minutes during
which the following message will be displayed on the Front Panel.
12. Once the OMAS Calibration Pattern has been printed successfully, the following message will be
displayed on the Front panel. Press the Enter key to continue.
If the OMAS Calibration fails for any reason, a warning message will appear on the Front Panel. In
this case, try the following:
• Retry the Paper Advance Calibration.
Scan OMAS Calibration Pattern
1. You will need to re-enter the OMAS Calibration submenu and scroll to “Scan Calibration Pattern”
and press Enter.
2. When the following message appears on the front panel, you must select whether you would like to
continue with the calibration by pressing the Enter key. Press Back or Cancel to exit the
calibration.
NOTE: Remove the pattern from the printer and leave it to dry for a few minutes before
continuing with the Calibration.
NOTE: MAKE SURE NO MEDIA IS LOADED INTO THE PRINTER BEFORE STARTING TO
SCAN THE OMAS CALIBRATION PATTERN.
To Next Page
Loading...