178 Chapter 5 Service Calibrations
Service Calibrations
3. A message will appear on the Front Panel requesting you to raise the Media Lever and to place a
sheet of white media on the Print Platen aligned with the Blue Line. Press the Enter key to continue
once the sheet is in placed.
4. The Printer will start to calibrate the Blue Line and the following message will be displayed on the
Front Panel.
5. Once the Blue Line has been calibrated, the following message will be displayed on the Front Panel.
Open the Window and remove the sheet of media that you had placed on the Print Platen. Press any
key on the Front Panel to continue once the sheet of media has been removed.
6. The results of the calibration will be displayed on the Front Panel. Press any key on the Front Panel to
finish the calibration.
7. Once the calibration is completed, OK will be displayed on the Front Panel.
To Next Page
Loading...