276 Chapter 8 Removal & Installation
Removal & Installation
1. Position the Metallic Support on to the Top Cover.
2. Lock the Metallic Support on to the Top Cover.
3. Install the T-20 screw that secures the Metallic Support
to the Top Cover.
4. Remove the Window (
⇒
See page 260
) from the old
Top Cover and install it on the new Top Cover.
NOTE: When installing the Ink Supply Tubes
and Trailing Cable on to the Top Cover, take
note of the of the two red marks on the Ink
Supply Tubes. These two red marks should be
aligned with the first slot in the Top Cover as
this will help with the rest of the installation.
To Next Page
Loading...