342 Chapter 8 Removal & Installation
Removal & Installation
17. Move the Carriage Assembly slightly away from the
right Scan-Axis Bracket.
18 . Release the Carriage Belt from the Scan-Axis Motor on
the left hand side of the Printer.
19. Remove one T-10 screw (Type C) that secure the
Encoder Strip.
20.Remove four T-20 screws (Type N) that secure the right
Scan-Axis Bracket.
NOTE: Note that these are Chassis screws
and in normal circumstances should NEVER be
removed, but in this case we need to remove
them in order to remove the Carriage Assembly.
To Next Page
Loading...