Carriage Assembly 343
Removal & Installation
21. Remove the right Scan-Axis Bracket from the Printer.
22.Remove the Carriage Stopper Screw (T-20) from the
Chassis.
23.Remove the Carriage Stopper from the Printer.
24.Slide the Carriage Assembly (including the belt) to the
right and out of the Printer.
25.If the Carriage Assembly is to be replaced, make sure
that you remove the Belt, the Carriage PCA, Color
Sensor, Encoder and Line Sensors and the Cutter
Assembly (in order to install them on the new Carriage
Assembly).
NOTE: After installing the NEW Carriage
Assembly, make sure you perform the following
Service Utility:
To Next Page
Loading...