Center Platen 401
Removal & Installation
8. Insert the T-20 thin bladed torx screwdriver (supplied
with the replacement OMAS) into the access hole at
the rear of the printer.
9. Loosen approximately two turns the T-20 screw which
secures the OMAS horizontally to the printer.
10. From the bottom of the printer, loosen approximately
two turns the T-20 screw which secures the OMAS
vertically to the printer.
11. Remove one T-15 screw (Type P) that secures the
Center Platen Gear.
To Next Page
Loading...