406 Chapter 8 Removal & Installation
Removal & Installation
page 351.
2. Install the Center Platen.
3. Position the Attachment Screw Retainer on the OMAS
and secure it with the T-8 attachment screw provided
with Center Platen.
4. Verify that the two T-20 attachment screws are correctly
positioned in the Attachment Screw Retainer.
5. Position the OMAS under the Printer and connect the
large ribbon.
NOTE: When reinstalling the parts, make sure
you apply the grease (included with the support
part) to the gears.
To Next Page
Loading...