Center Platen 407
Removal & Installation
6. Lock the clips of the large ribbon cable connector.
7. Carefully push the OMAS fully up into its mounting so
it protrudes slightly (approximately 0.1 mm) above the
Center Platen. To ensure the OMAS is correctly
positions, slide a sheet of paper over the Platen Ribs
until it is stopped by the OMAS. This ensures the
OMAS is protruding slightly above the platen.
8. If the paper is not stopped by the OMAS, repeat
step 4 to ensure the OMAS is push fully up into its the
mounting.
9. Fully tighten the T-20 vertical attachment screw.
CAUTION: Make sure the OMAS is pushed
completely up into its mounting or you will
encounter an error during the OMAS
calibration because it will not be able to focus
on the paper.
To Next Page
Loading...