HP Designjet Z6100 Printer series - Page 443

Drive Roller 433
Removal & Installation
Drive Roller
Removal
1. Remove the Right Cover ⇒ See page 264 .
2. Remove the Left Cover ⇒ See page 270.
3. Remove the Right Connector Cover ⇒ See page 281.
4. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 287.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 288.
5. Remove the Service Station ⇒ See page 300.
6. Remove the Ink Supply Station ⇒ See page 321.
7. Remove the Media-Axis Motor ⇒ See page 349.
8. Remove the Encoder Disc and Sensor ⇒ See page 417.
9. Remove the Media Lever Assembly ⇒ See page 420.
10. Remove the Media Sensor ⇒ See page 423.
11. Remove the Center Guide ⇒ See page 430.
12. Remove two T-10 screws that secure the Drive Roller
Gear.
13 . Remove the Drive Roller Gear from the Printer.
WARNING!: Switch off the printer and remove the power cable.