Special Set-up checks and re-packaging instructions for EMU units 465
Repacking
Carefully read the Instructions
Carefully read this document and ensure the processes described are performed properly. This way, every
time the printer user has to unpack and set-up the unit, it will be as stated in the set-up poster.
ReUse the packaging material
Do not throw or dispose the packaging components as they have to be reused every time the printer needs
to be shipped to elsewhere.
There are generic packaging components like the adhesive tape, plastic strips, etc. that can not be reused
in all the cases. Ensure you have some spare tape to complete the packaging process (industrial tape can
be used in most of the cases)
There are critical packaging components, listed on next pages, designed to lock some printer system
during transportation. These components must be stored until re-packaging is needed.
If these components are not available, thus not installed. the transport conditions may damage some
printer components.
Check the printer status before switching on the unit
Attached you will find some instruction on basic checks before the unit is turned on. By checking these,
the customer can ensure that the unit is ready to work, even after lot of transport cycles (In most of the
cases!).
The objective of this document is to explain the process of re-packaging a printer for
further shipments
Do not dispose the packaging elements
To enable the proper re-packaging of the printer it is very important to keep the packaging elements that
initially came with the units.
These elements once re-installed will ensure that the printer that be shipped elsewhere withstanding the
normal transport conditions.
The main packaging elements required to repack the printer are:
To Next Page
Loading...