Step 2: Re-installing the retention parts 477
Repacking
• Insert the carton pad in the Right spindle support, to prevent it from moving during
transport.
All the transport retention parts have been installed now. Next packaging steps are the reverse process
to the one described in the Set-up Poster.
The summarized steps follow:
• Cover the printer with the antistatic bag & install both Foam End-caps.
• Detach the printer from the stand and place it on the pallet. Ensure that the printer is flipped
upside down to enable the later installation by next customer.
Disassemble the TUR & STAND and pack it in its original boxes, following the reverse set-up process.
Once the printer is on the pallet, close the bag and secure it with adhesive tape.
To Next Page
Loading...