480 Chapter 10 Repacking instructions
Repacking
Refer to the attached pictures
Ink tubes are placed back in its tube guide, as shown in the picture above.
Check the Left spittoon absorber is installed
This part comes installed in the printer, and should not be replaced until the front panel shows the
message, but due to the several printer shipments required, to prevent from ink spillage we are requesting
in some cases to remove this component before packaging the unit.
In the case that the absorber is not heavily used (easily identifiable by checking the ink dirtiness on it), it
does not need to be removed during transport.
In any case, it is important to check that the absorber is installed into the left spittoon. This can be done
by opening the window and locating it on the left side of the print platen, as shown in the attached picture.
To Next Page
Loading...