Continuable and Non-Continuable Error Codes 47
System Error Codes
Continuable and Non-Continuable Error Codes
Some of the Error Codes are continuable, which means you can press Enter on the front-panel and
continue working with the Printer. Non-Continuable Error Codes do not allow you to continue working
with the Printer, in this case power the Printer OFF and ON again and see if the System Error disappears.
If the Error Code reappears, then the Printer requires an on-site visit in order to resolve the problem.
Important note: If the solution calls for a replacment part, replace one component at a time and check
if the error has been cleared before replacing another component. Using this procedure you will be able
to determine exactly which component has failed.
System Error:
01.0:03
Problem Description:
Error impact I2C channel.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• If the System Error continues, replace the Sausalito PCI PCA ⇒ Page 369.
System Error:
01.0:10
Problem Description:
Problem with the Sausalito PCI PCA.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Replace the Sausalito PCI PCA ⇒ Page 369.
• If the System Error continues, replace the Main PCA ⇒ Page 375.
System Error:
01.1:10
Problem Description:
Problem with the PrintMech PCA.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the cables between the PrintMech PCA and the Sausalito PCI PCA are not damaged and
are correctly connected.
To Next Page
Loading...