HP Designjet Z6100 Printer series - Page 76

66 Chapter 2 System Error Codes
System Error Codes
Corrective Action:
Try the following:
• Check that the Maintenance Cartridge Door Sensor
cable is not damaged and is correctly connected
to the Interconnect PCA .
• Replace the Maintenance Cartridge Door Sensor.
System Error:
52:01
Problem Description:
Drop Detector fiber detected.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Replace the Drop Detector ⇒ Page 309.
System Error:
52:10
Problem Description:
Drop Detector switch On/Off failure.
Corrective Action:
Try the following:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the
Drop Detector cable is not damaged and is correctly connected to the Service Station
cable
.
• Check that the
Service Station cable is not damaged and is correctly connected to the Interconnect
PCA
.
• Replace the Drop Detector ⇒ Page 309.
• R
eplace the Sausalito PCI PCA ⇒ Page 369.
• If the System Error continues, replace the Interconnect PCA ⇒ Page 357.
System Error:
53:10
Problem Description:
Media sensor.
Corrective Action:
Try the following:
• Check that the
Media Sensor cable is not damaged and is connected correctly to the Interconnect
PCA
.