●
Part number
●
PostScript language (if applicable)
1. In the Diagnostics menu, scroll to Unit Information and press OK.
2. The printer starts to initialize and the front panel displays the following messages:
●
Starting Nvm
●
Getting FW version
●
Getting Serial Number
●
Getting Part Number
If there is a failure at this point, the front panel displays System Error Code 79:03. For
more information on troubleshooting this error code, see
SE 79:03 on page 68.
●
Getting PS Language (if the PostScript accessory is installed)
If there is a failure at this point, the front panel displays an error.
3. Once the unit information is obtained, it is displayed on the front panel. Press OK to exit.
EEROM Reset
The purpose of this diagnostic is to reset the EEROM values.
NOTE: Once the EEROM has been reset, the printer will act as if it is being started for the first time,
except that the Ink Supply Tubes have already been primed.
1. In the Diagnostics menu, scroll to EEROM Reset and press OK.
ENWW
Entering the Service Tests menu
101
Service tests and
utilities
To Next Page
Loading...
