4. Check that the Take-Up Reel motor assembly is correctly connected to the rear of the printer.
How the Take-Up Reel works
When selecting the front panel's Paper menu, if there is no line Take-Up Reel installed, this
indicates that the Take-Up Reel has not been enabled at the front panel. This does not mean that the
Take-Up Reel will not work; it just means that, if there is a paper jam detected by the Take-Up Reel,
there will be no warning system error displayed on the front panel. The printer will not stop.
How to install the Take-Up Reel
From the Paper menu > Take-Up Reel > Enable Take-Up Reel. After this is done, you will notice
the following differences:
●
In case of Take-Up Reel Paper jam system error, a warning is reported on the front panel, and the
printer pauses.
●
The cutter is disabled between jobs.
●
When unloading the paper, the front panel will ask you to cut the paper manually.
How it works
When the bottom of the 'loop shaper' is low enough and it cuts the signal between the two sensors, the
Take-Up Reel starts to move the motor until the signal between the two sensors is passing through
again.
If, after a few seconds of turning the Take-Up Reel, the signal between two sensors is still cut, the Take-
Up Reel reports a 'Take-Up Reel paper jam' error:
●
In all cases, the LED of the Take-Up Reel is blinking quickly.
●
If the Take-Up Reel is enabled at the front panel, a Take-Up Reel paper jam will be displayed.
12 Chapter 1 Troubleshooting ENWW
Troubleshooting
To Next Page
Loading...
