5. Rotate the Right Connector Cover a few degrees counter-clockwise so it can be removed
completely. Rotate the Right Connector Cover a few degrees counter-clockwise so it can be
removed completely.
6. Remove the Right Connector Cover from the printer.
Left Connector Cover (42-inch)
Removal
WARNING! Switch off the printer and remove the power cable.
NOTE: Throughout this section the graphics actually show the HP Designjet 4000 printer series but
the steps of the procedure are identical for the HP Designjet Z6000 printer series.
1. Remove the Rear Door See Rear Door (42-inch) on page 235.
240 Chapter 8 Removal and installation ENWW
Removal and
installation
To Next Page
Loading...
