29. Disconnect the cable.
30. Remove the Ink Supply Tubes and Trailing Cable from the printer.
Installation of the Ink Supply Tubes and Trailing Cable
NOTE: After installing the NEW Ink Supply Tubes and Trailing Cable, make sure you perform the
following Service Utility:
●
Reset life counter scan cycles tubes/cable
Reset Life Counters on page 108.
NOTE: When installing the Ink Supply Tubes and Trailing Cable on to the Top Cover, take note of the
of the two red marks on the Ink Supply Tubes. These two red marks should be aligned with the first slot
in the Top Cover as this will help with the rest of the installation.
ENWW
Disassembly order
273
Removal and
installation
To Next Page
Loading...
