General calibrations
●
Printhead Alignment relates to the Printhead Alignment which changes to ‘pending’ when a
Printhead is replaced and the Printhead Alignment has not been performed.
NOTE: When a component is replaced, the corresponding calibration is not automatically set to
‘NOT DONE‘. This is because the printer does not know that there is a new part installed.
●
Drop Detector relates to the Drop Detector or Service Station calibration.
●
Line Sensor relates to the Line Sensor Calibration.
Media-specific calibrations
This section shows the following for each type of media:
●
Media Name
●
Color calibration and date
●
Paper Advance calibration and date
Printer status codes
This section shows status codes for the following:
●
Nozzle Health
●
Media Advance Calibration
●
Printhead Alignment
●
Closed Loop Color Calibration
These codes may be useful to detect potential print-quality issues. Several suggested actions are linked
with these codes, and are displayed in the Embedded Web Server and the front panel.
Connectivity configuration
This page contains full details of the current configuration of the printer.
ENWW
How to interpret the Service Information Pages
23
Troubleshooting
To Next Page
Loading...
