WARNING! Switch off the printer and remove the power cable.
1. Remove:
●
For the 42-inch model, the Left Connector Cover
See Left Connector Cover (42-inch)
on page 240.
●
For the 60-inch model, the Electronics Module Extension
See Electronics Module Extension
(60-inch only) on page 241.
2. Remove the Jetdirect Card (if installed).
3. Remove three T-20 screws that secure the Formatter cover.
4. Remove the Formatter Cover from the printer.
ENWW
Disassembly order
343
Removal and
installation
To Next Page
Loading...
