NOTE: Make sure you take note of the positions of the Foams located underneath the Print Platen.
NOTE: When reinstalling the parts, make sure you apply the grease (included with the support part)
to the gears.
NOTE: After installing the new Print Platen, make sure you perform paper-advance calibration
Paper-advance calibration on page 127.
NOTE: To simplify the installation of the OMAS an Attachment Screw Retainer has been added to
hold the two T-20 attachment screws. This part is delivered with the Print Platen in case either of the
OMAS attachment screws are completely removed during the removal of the Print Platen.
OMAS Attachment Screws Completely Removed during Print Platen Removal
1. Completely remove OMAS from the printer
See Optical Media Advance Sensor (OMAS)
on page 316.
2. Install the Print Platen.
NOTE: When reinstalling the parts, make sure you apply the grease (included with the support
part) to the gears.
ENWW
Disassembly order
369
Removal and
installation
To Next Page
Loading...
