6. Lock the clips of the large ribbon cable connector.
7. Carefully push the OMAS fully up into its mounting so it protrudes slightly (approximately 0.1 mm)
above the Print Platen. To ensure the OMAS is correctly positions, slide a sheet of paper over the
Platen Ribs until it is stopped by the OMAS. This ensures the OMAS is protruding slightly above
the platen.
CAUTION: Make sure the OMAS is pushed completely up into its mounting or you will
encounter an error during the OMAS calibration because it will not be able to focus on the paper.
8. If the paper is not stopped by the OMAS, repeat step 4 to ensure the OMAS is push fully up into
its the mounting.
ENWW
Disassembly order
371
Removal and
installation
To Next Page
Loading...
