CAUTION: Please handle the Encoder Disc very carefully since any finger prints, scratches or stains
could cause the printer to malfunction.
1. Remove the Left Cover See Left Cover on page 222.
2. Remove:
●
For the 42-inch model, the Left Connector Cover
See Left Connector Cover (42-inch)
on page 240.
●
For the 60-inch model, the Electronics Module Extension
See Electronics Module Extension
(60-inch only) on page 241.
3. Remove the Ink Supply Station
See Ink Supply Station (ISS) on page 276.
4. Disconnect the Encoder Sensor cable from the PrintMech PCA.
5. Release the Encoder Sensor cable from the clip located on the Electronics Module.
ENWW
Disassembly order
381
Removal and
installation
To Next Page
Loading...
