To make sure that ALL the datums are met when installing the Media-Axis Motor Bracket, make sure you
follow these
1. Place the Media-Axis Motor Bracket in the correct position on the printer. Make sure you keep it
pushed down (as shown in the illustration) until the first screw has been installed and fully
tightened.
2. Install the first screw (T-15) in the position shown. Make sure you tighten the screw fully so that the
Media-Axis Motor Bracket cannot be moved.
3. Check that there is no play (movement) between the Media-Axis Motor Bracket and the Drive
Roller. If there is play, then check that the screw installed in the previous step is fully tightened.
406 Chapter 8 Removal and installation ENWW
Removal and
installation
To Next Page
Loading...
