3. Open the Window.
4. Clean the Encoder Strip as shown in the front panel, and press OK when finished.
5. Close the Window. The Carriage moves to the left-hand side of the printer.
6. The front panel prompts you to reopen the Window and clean the right-hand side of the encoder
strip (inside the Service Station). Press OK when finished.
7. Close the Window. The Carriage returns to its ready position in the Service Station.
Clean the paper-advance sensor window
The paper advance sensor is the very small rectangular window (less than 1 square centimeter in size
and shown in the following graphic) near the sixth platen roller from the right.
ENWW
Preventive maintenance
423
Preventive
maintenance
To Next Page
Loading...
