HP Designjet Z6200 - Page 54

Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Trailing Cable is not damaged.
●
Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and
Main PCA.
●
Replace the Carriage PCA
Carriage PCA on page 296.
SE 03:10
Cause: Power distribution failure
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the Power Supply Unit's blue LED is on, replace the PrintMech PCA. If not, replace the Power
Supply Unit.
SE 05:10
Cause: Formatter communication failure with ISS
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the Formatter to PrintMech PCA cable is correctly connected.
●
If the system error persists, replace the Formatter
Formatter on page 338.
SE 05.1:10
Cause: Formatter CPU fan stopped or burnt
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
If the system error persists, replace the Formatter
Formatter on page 338.
SE 06:03
Cause: Main NVM communication failure
44 Chapter 2 System error codes ENWW
System error codes