Solution: Try the following:
●
Check that the Main PCA to PrintMech Blue 2 cable is not damaged.
●
Check that the Main PCA to PrintMech Blue 2 cable is correctly connected to the Main PCA and
the PrintMech PCA.
●
Replace the Main PCA to PrintMech Blue 2 cable (which is included in the Electronics Module
Cable Kit).
SE 21:03
Cause: Service Station electrical current limit
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Make sure that the Service Station path is clear. Remove any visible obstacles (such as foam from
the printer’s packaging, screws and plastic parts) restricting the movement of the Service Station.
●
If the System Error continues, replace the Service Station
Service Station on page 252.
SE 21:13
Cause: Service Station jam
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Make sure that the Service Station path is clear. Remove any visible obstacles (such as foam from
the printer’s packaging, screws and plastic parts) restricting the movement of the Service Station.
●
If the System Error continues, replace the Service Station
Service Station on page 252.
SE 23:10
Cause: Air Pressurization System failure; unable to pressurize or depressurize tubes
Solution: Try the following:
●
Turn the power off at the rear of the printer and disconnect the power cord. Reconnect the power
cord and turn on the printer.
●
Check that the APS cable is not damaged and is correctly connected to the PrintMech PCA.
●
Check that the air tubes are properly connected and are not kinked or pinched.
●
Replace the APS Assembly
APS Assembly on page 283.
SE 24:03
Cause: Ink Supply Tubes purge failure
ENWW
Continuable and non-continuable error codes
47
System error codes
To Next Page
Loading...
