However, if you plan to store the printer indefinitely, you are recommended to power it off using the Power
key, and then also switch off the power switch at the rear. Also, if the Power key does not seem to work, you
can use the switch at the rear instead.
To turn it back on, use the power switch at the rear.
When the printer is powered back on, it takes about three minutes to initialize and check and prepare the
printheads. Preparing the printheads takes about one minute and 15 seconds. However, if the printer has
been off for six weeks or more, preparing the printheads could take up to 45 minutes.
ENWW Turn the printer on and off 11
To Next Page
Loading...