HP ProLiant DL360 G3 Server High-Density Deployment
Preliminary
5
ProLiant DL360
G3 Server Power
Requirements
In the standard single-processor configuration, the ProLiant DL360 G3 server includes
one 325-watt power supply that can operate off high or low voltage AC power. Single
power supply units can be upgraded to a dual-power supply configuration with a
redundant power supply option kit. The power supplies are hot-pluggable, allowing live
removal and replacement.
The ProLiant DL360 G3 server uses an IEC C14-type AC plug that requires a power
cable with an IEC C13 receptacle at one end. Power cord kits that are compatible with
the physical and electrical requirements of the DL360 G3 server are available from HP
and listed later in this document.
The ProLiant DL360 G3 server power specifications are provided in the following table
using values derived from the product specification as well as the Power Calculator utility
with a server in nominal and maximum configurations.
Table 2. ProLiant DL360 G3 Server Power Specifications
Input Voltage
100 115 208 220 230 240
Power Supply Rated Output
(W)
325 325 325 325 325 325
Nom. Input Wattage (W) 234 232 227 224 222 220
Max. Input Wattage (W) 338 336 329 326 324 321
Nom. Input Current Draw (A) 2.4 2.1 1.1 1.0 1.0 0.9
Max. Input Current Draw (A) 3.5 3.0 1.6 1.5 1.4 1.4
Nom. Input (Va) 238 237 231 228 227 225
Max. Input (Va) 345 343 336 332 330 328
Max. Thermal (Btu/Hr) 1154
1146
1123
1111
1104
1095
Efficiency (%) 72.1 72.6 74.1 74.9 75.4 76.0
Power Factor 0.98 0.98 0.98 0.98 0.98 0.98
Nom. Leakage Current (Ma) 0.31 0.36 0.65 0.69 0.72 0.75
Max. Leakage Current (Ma) 0.63 0.72 1.30 1.38 1.44 1.50
Nom Inrush Current (A) @ 2
Ms
30 30 30 30 30 30
Max Inrush Current (A) @ 2
Ms
60 60 60 60 60 60
NOTES:
Nom. = Nominal rating of a unit operating w/ one processor, 1HDD, up to 2
DIMMs, and no PCI cards.
Max. = Maximum rating of a fully loaded unit: 2 processors, 2HDD, 4 DIMMs, 1 PCI
cards, and 2 power supplies.
These values are derived from a combination of product specifications and the Power
Calculator configured as above in “Nom” and “Max.”
To Next Page
Loading...
