Hardware options installation 54
1.
Remove the drive blank.
2. Prepare the drive.
3. Install the drive.
4. Determine the status of the drive from the drive LED definitions (on page 17).
Removing a hot-plug SAS or SATA hard drive
CAUTION: For proper cooling do not operate the server without the access panel, baffles,
expansion slot covers, or blanks installed. If the server supports hot-plug components, minimize
the amount of time the access panel is open.
1. Determine the status of the hard drive from the hot-plug SAS hard drive LED combinations ("Drive LED
definitions" on page 17).
2. Back up all server data on the drive.
http://www.storagenetworks.com/products/servers/hp/DL380G8/dl380pg8_servers_landing.php
To Next Page
Loading...
