Component identification 12
• Installing the risers listed in the table above in either the primary or secondary riser connectors
determines the form factor of the PCI cards supported by those risers.
• FL/FH denotes full-length, full-height. HL/FH denotes half-length, full-height. LP denotes low profile.
• The PCIe2 x16 riser supports a maximum power of 225W with an HP power cable. This cable must
be used for PCIe card wattages greater than 75W.
System board components
Item Description
1 Processor 2 memory sockets
2 Front I/O connector
3 USB tape connector*
4 SATA optical drive connector
5 USB connector
6 Power supply backplane connector
7 System maintenance switch
To Next Page
Loading...
