HP DL385-G7 - Remove the PCI Riser Cage

Operations 25
o
If there are any full-length expansion boards installed, remove the full-length expansion board
retainer as follows:
Remove the PCI riser cage
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all PCI slots have either an expansion slot cover or an expansion board installed.
1. Power down the server (on page 22).
2. Extend the server from the rack (on page 22).
3. Remove the access panel (on page 23).
4. Remove the full-length expansion board retainer (on page 24) if necessary.
5. Remove the PCI riser cage.