Server Specific Troubleshooting 109
3. Insert the ROMPaq diskette.
4. Power up the server ("Powering Up the Server" on page 29).
a. The server generates one long beep and two short beeps to indicate that
you are in disaster recovery mode. If the diskette is not in place, the
system continues to beep until a valid ROMPaq diskette is inserted.
b. The ROMPaq diskette flashes both system ROM images. If successful, a
sequence of ascending audible beeps is generated. If unsuccessful, a
sequence of descending audible beeps is generated and you need to
repeat the disaster recovery process.
5. Power down the server ("Powering Down the Server" on page 29).
6. Remove the ROMPaq diskette.
7. Power up the server ("Powering Up the Server" on page 29).
To manually set the server for ROMPaq disaster recovery:
1. Power down the server ("Powering Down the Server" on page 29).
2. Remove the access panel ("Removing the Access Panel" on page 32).
3. Set positions 1, 4, 5, and 6 of the system maintenance switch to On.
4. Insert a ROMPaq diskette with the latest system ROM from the SmartStart
CD or the HP website (http://www.hp.com/servers/manage
).
5. Install the access panel ("Installing the Access Panel" on page 32).
6. Power up the server ("Powering Up the Server" on page 29).
7. Allow the system to boot completely.
8. Repeat steps 1 and 2.
9. Set positions 1, 4, 5, and 6 of the system maintenance switch to Off.
10. Repeat steps 5 and 6.
Other Information Resources
For additional troubleshooting information, refer to the Servers Troubleshooting
Guide on the Documentation CD.
HP CONFIDENTIAL
File Name: 303212-1new.doc Last Saved On: 11/4/02 10:51 AM
To Next Page
Loading...
Need help?
General